📄️ Datasheet
This board is designed to support all the basic functions of the INAV and Ardupilot projects.
📄️ Firmware
To flash the firmware and set up use the official guide!
📄️ Sensors (GPS + Compass)
Vektor Autopilot runs the ArduPilot (Rover/Sub) firmware, so any sensor supported by these platforms should function correctly. Sensors must be connected via UART or I²C, as CAN is not supported.
📄️ Wiring
Basic wiring
📄️ Common power and signal rails
The VEKTOR Autopilot includes ports that share the same power line or signal. The graphics below illustrate these shared connections for better understanding: