Servo PowerPack NEW
SKU: 1506
Installation
Do not put the pins where they can make contact with conductive surfaces. Keep a clearance of at least 4mm between the PowerPack and conductive surfaces. We suggest to enclose the module with its wiring in a heat shrink tubing or use 3D printed supports in PLA or ABS.
Check the correct polarity of the connector on the bottom side of the PowerPack.
The PowerPack can be mounted in any direction as long as the polarities are correct.
Capacitor carrier board. Improves current management in the electrical circuit and flattens the ripple effect caused by fast or heavy servo movements.
Improves current management in the circuit and smoothes the ripple effect caused by fast servo movements.
High power Servos can create up to 50W peaks, sometimes more. If there is insufficient power supply, this can cause the servovs to shake or the entire circuitry to fail.
- Suited for servos on Voith-Schneider Propellers
- Also suited for servos used in Cranes or Robots
- Operating voltage from 5V to 14V
- Designed to be used in constrained space
- Standard JR servo connector on both ends
- Also improves cable management
This product is not an independently functional unit and DOES REQUIRE professional installation and configuration.
PROFESSIONAL INSTALLATION REQUIRED: CAPACITORS MAY EXPLODE OR CATCH FIRE !!!
* The appearance and design of the board are subject to changes. The functionality and size always remain unchanged.
Manufacturer: SEAWORKS.IO